Not to be a 3d print snob but....

Aside from the failure it looks like it wasn't the best print to start with. Lots of rashing from support and curling at the edges. You can see on the flats where the support was and the outer curve of the elbow looks like it likely wasn't airtight. Appears to me to be printed with the inlet facing upwards.

Better support planning, settings and possibly orientation may have helped.

Other commenters are saying it was likely PLA-CF, which I totally agree with based on the testing, but I can't help but think there is no possible way the person printing this item did not know that. I doubt the print would have come off as good as it did when using ABS-CF settings on PLA-CF.

Big chain of poor choices.