alt Hacker NewsI would hesitate to say the IKEA is worse. Inside the IKEA is a reputable Sensirion all in one sensor module. It's much cheaper and smaller because the CO2 sensor in it is using different (newer) technology that only released a few years ago from Sensirion.
(Upd: the IKEA does have lower accuracy, with ±100 ppm instead of ±30 ppm. From the SEN63C datasheet)
Replies
No, it is crap. Yes, it is Sensirion, but it uses a thermal conductivity sensor, which is a very indirect method of measuring CO2. One part of the sensor emits heat and the other senses it and the idea is that heat transfer changes with different CO2 concentrations. However, a lot of other factors influence this as well, such as ambient temperature/humidity (which is why the sensor incorporates measurements from an SHT sensor), but also gas mixture, etc. You only get good readings at lab conditions. Even below 1000 ppm, I would often see readings that are 300 ppm from more expensive, known-good CO2 meters.
If you want a CO2 meter on the cheap, either wire up an optical NDIR sensor like the SenseAir S88 (22 Euro) up to an esp32, which is possibly the best sensor you can get for the money (slightly cheaper version of the sensor that the AraNet4 uses). Or if you want something standalone with a display, get the SwitchBot Meter Pro CO2 for ~50 Euro, which uses a photoacoustic NDIR, but is still miles better than the sensor in the ALPSTUGA. Can also be hooked up with HA through an ESPHome BLE proxy or with the SwitchBot Hub.
You can find a comparison of the IKEA sensor with other affordable sensors here:
https://danieldk.eu/hardware/smart-home/ikea-alpstuga
(Upd: the IKEA does have lower accuracy, with ±100 ppm instead of ±30 ppm. From the SEN63C datasheet)
You forget to mention that it is ±100ppm plus ±10% of the ambient ppm, which makes a big difference. At 1000ppm it's ±(100ppm + 0.10*1000) = 200ppm and that's only in an environment with 25C, 50% RH, and 1013 mbar. So, that does not tell you much, given that thermal conductivity is very sensitive to environmental factors.
Worse specs? Sure. Worse value? I don't think so. Worse accuracy? Perhaps not either.
A price of 30 EUR makes this sensor really easy to pick up. For the same price as one Aranet (~180 EUR) the typical household can place a sensor in every room of the house. Which provides far more accurate readings for the whole house than just one high-end sensor in one room.