alt Hacker NewsDropped rods are an incident but one that occurs because of pressurized water reactors being very default safe. Controls rods are one way the criticality of a reactor is controlled and US reactors (in general) will go sub critical if even one rod is fully inserted into the core. You will likely have heard of a reactor scram (which goes back to the safety control rod ax man) where in an emergency, all the rods are dropped back into the core, greatly reducing its criticality. In some cases, an interruption of electrical power will cause a rod (or three) to drop accidentally. This is a "dropped rod" incident and will force a reactor shut down because it is now sub critical.
Lots of knock on effects -- sub critical, let heat in the primary loop, less steam and electricity generated in the secondary loop, etc -- but generally a non event that you practice for.
There's no reason this would lead to a radiological event or more significant casualty.
Replies
OG article makes it seem the control rods detached/broke off from an actuator mechanism right into the core.
As someone who’s had to fish out things from awkward places (and sometimes to lose them again right after), I started wondering how they’d be getting it out.
In case you weren’t aware, the “safety control rod ax man” thing is aprocryphal and almost certainly not reflective of the origins of the term.
Well, we don't know exactly why the reactor was manually shut down. Did the person actually know that the control rods had dropped? Or was it reported by sensors? I suspect the procedure us to initiate shutdown in response to any reports of uncommanded rod behavior. I doubt they would wait around to see if this was a sensor or reporting system error.
Thats a releaf, nothing like an uncontrolled saftey event to take a bit of pressure off
I think you said it: it's a non-event. It's the reactor reactor-ing within the design basis. But, I think "single rod-drop" will not shut down a reactor. That's a crazy amount of rod-worth. My opinion is that reactor safe-shutdown margin entails "single rod-stuck" scram to be feasible.
>generally a non event
depends on what your priors are. Is a dropped rod a fukashima or chernoble international emergency? No.
However, depending on the design characteristics of the core, dropping rods lowers the heat distribution proximal to the dropped rod(s), but may result in higher peaks distal to the rods as physics characteristics attempt to maintain the average, which may exceed design limits.
Furthermore, rods aren't supposed to drop. How that came to pass is a matter that requires honest investigation - manufacturing/quality control, maintenance practices, personnel error? Much to learn to ensure safety.
Saying "we just had to rely on a critical reactor safety feature and scrammed, this is a nonevent" doesnt quite hit the mark.
Maybe a non-event for safety but what about getting the plant operating again?