MangoJelly’s FreeCAD courses on YouTube took me from zero to dangerous enough to design my own prints. I appreciated his approach of modeling a part and then modeling it again with an improved method.
I've watched a fair number of these, but I always get hung up on some tiny little interface difference which confuses me.
Even bought a book which was purportedly for 1.1 (according to a bar across a corner of the cover), but when I got it, the text referenced 1.0 and the screengrabs were also for the older version.
I am hopeful that the UI will settle down sufficiently with the nascent 26.3 that learning materials will catch up.
I've watched a fair number of these, but I always get hung up on some tiny little interface difference which confuses me.
Even bought a book which was purportedly for 1.1 (according to a bar across a corner of the cover), but when I got it, the text referenced 1.0 and the screengrabs were also for the older version.
I am hopeful that the UI will settle down sufficiently with the nascent 26.3 that learning materials will catch up.